• Follow us
Home > Blog > Content
Mechanical Parts Detection in Machine Halt
Jan 22, 2018

Mechanical Parts Detection in Machine Halt


     Mechanical parts play a vital role in the use of machinery, so we must carry out regular maintenance and maintenance, in order to improve the performance of machinery and equipment, prolong the service life of mechanical parts. When the machine stops, it is necessary to check the correlation of the parts to ensure the safe use of the parts.

1. It is important to keep the bearings and lubricated clean.

     Clean the surface of the machine before inspection, then remove the parts around the bearing. The oil seal is a very fragile part, so it should be carefully removed, do not exert excessive force, and then carefully check the oil seal and its surrounding parts. If you have shown bad symptoms, be sure to replace, bad oil seal will lead to bearing damage and severe equipment shutdown.

2. Lubricant checking

    Apply a touch of lubricant between the two fingers. If there is contamination, feel it, or apply a thin layer of lubricant on the back of the hand, and then seal the light.

3. Replacement of lubricants

     Oil lubricated bearings are poured into fresh oil and rotated at a low speed for a few minutes, if possible, after being drained out of old oil. As far as possible, the oil collects residual contaminants, and then releases the oil. The oil had better be filtered before use.

     Grease lubricated bearings used in the replacement of grease should be used to remove Joe remover from any part of the bearing with cotton joint because these residual fibers may wedge between the rolling parts and cause damage. In particular, the application of small bearings should pay more attention to this problem.

4. covered with exposed bearings

    Never allow bearings to be exposed to contaminants or moisture when checking bearings. If work is interrupted, cover the machine with oil-paper plastic sheets or similar materials.

     If the bearing is cleaned without removal and possible inspection, apply the applied brush with the oil solvent white spirit. Dry with a piece of fabric or blow dry with compressed air. (note that bearing components do not start rotating.